LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2288 (Rear Axle - Repair) >> Output Shafts >> 33 21 071 Replacing both gaiters on left and right of output shaft >> Removing and installing outer gaiter

Removing and installing outer gaiter

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Release hose clamps (1, 3) and detach gaiter (2) from output shaft.

Clean joint and output shaft carefully.

NOTE: All traces off old grease must be removed.

Check joint for damage; if necessary, replace OUTPUT SHAFT .

Fill joint with propeller shaft grease.

Fit gaiter (2) on bellows and secure with hose clamps (1, 3).

Fig 1: Identifying Gaiter With Hose Clamps
G04726476Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals