31 53 040 Removing and installing/replacing right output shaft bearing block

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: N62, N63:
Danger of explosion!
There is a danger of short circuiting on account of the small distance between the bearing block screw connection and the starter motor.
Disconnect BATTERY NEGATIVE LEAD .

Necessary preliminary tasks:

Remove RIGHT OUTPUT SHAFT

Release screws (1).

Remove bearing block from oil sump.

Installation:

Replace O-RING

Tightening torque 31 60 1AZ .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove sealing caps