24 34 021 Replacing sealing sleeve for transmission housing (GA6HP19Z) (X6 35i)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

24 2 390

IMPORTANT: After completion of work, check transmission oil level .
Use only approved TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove heat shields
Remove transmission cross-member . See 22 32 050 REPLACING CROSSMEMBER FOR TRANSMISSION MOUNTING (N54) or 22 32 050 REPLACING CROSSMEMBER FOR TRANSMISSION MOUNTING (N63) .
Remove transmission oil sump

IMPORTANT: Support transmission with workshop hoist.

Unlock and disconnect plug (1) by turning.

Fig 1: Disconnecting Plug

G04726084

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 2: Inserting Special Tool 24 2 390 In Sealing Sleeve

G04726133

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock sealing sleeve with slide (1).

Fig 3: Unlocking Sealing Sleeve

G04726136

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation note:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!

Fig 4: Pulling Out Sealing Sleeve

G04726137

Courtesy of BMW OF NORTH AMERICA, INC.