24 31 010 Replacing torque converter shaft seal (GA6HP26Z) (X6 50i)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Necessary preliminary tasks:
- Remove AUTOMATIC TRANSMISSION .
IMPORTANT:
After completion of work, check TRANSMISSION FLUID LEVEL .
Use only approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
Use only approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the transmission.
Secure transmission with special tool 24 0 200 to assembly stand 00 1 450 .
Remove TORQUE CONVERTER .
NOTE:
Read and comply with note on installation of transmission retaining bridge
.
Attach special tool 24 2 353 (synchronizing key) to drive shaft (1).
Screw in special tool 24 2 351 (puller) until it is firmly connected with shaft seal.
Screw in special tool 24 2 352 (spindle) to remove shaft seal.
Oil sealing lip on shaft seal.
Drive in shaft seal (1) with special tool 24 2 360 (mandrel) as far as it will go.