24 14 001 Replacing selector shaft seal (GA6HP26Z) (X6 50i)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

IMPORTANT: After completion of work, check TRANSMISSION FLUID LEVEL .
Use only the approved TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove UNDERBODY PROTECTION .

Unfasten nut.

Remove cable (1).

Installation note:

Adjusting cable:

Release nut
Adjust cable by means of holder (2)

Distance A ≥ 1 mm.

Fig 1: Identifying Cable, Holder With Distance

G04794137

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten nut.

Take off holder (1).

Tightening torque 24 51 1AZ .

Fig 2: Identifying Holder And Nut

G04755670

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 5 361 (bush) until it is firmly connected with shaft seal.

Fig 3: Identifying Special Tool 24 5 361

G04726125

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 24 5 362 (nut) onto special tool 24 5 361 (bush) and tighten down.

This pulls the shaft seal out of the transmission housing.

Fig 4: Identifying Special Tool 24 5 362 And 24 5 361

G04726126

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal (1).

Screw in shaft seal (1) with special tools 24 5 366 (bush) and 24 5 364 (nut) as far as it will go.

Fig 5: Identifying Shaft Seal With Special Tools 24 5 366 And 24 5 364

G04726127

Courtesy of BMW OF NORTH AMERICA, INC.