24 13 013 Replacing output flange shaft seal (GA6HP19Z) (X6 35i)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 0 490
24 4 310

IMPORTANT: After completion of work, check FLUID LEVEL .
Use only the approved TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove UNDERBODY PROTECTION .
Remove TRANSFER BOX

Drive a hole into radial shaft seal (1) using a center punch.

IMPORTANT: Do not use a drill as drillings may result in transmission malfunction.

Screw special tool 23 0 490 into radial shaft seal (1).

Drive out radial shaft seal (1) with impact weight (2).

Fig 1: Screwing Special Tool 23 0 490 Into Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Coat sealing lips of new radial seal with clean transmission oil.

Drive shaft seal firmly home with special tool 24 4 310 .

Fig 2: Driving Shaft Seal Using Special Tool 24 4 310

Courtesy of BMW OF NORTH AMERICA, INC.