11 53 000 Removing and installing/replacing coolant thermostat (N54, all-wheel drive)

WARNING: This page is about a different car, the 2010 BMW X6, 2009 BMW X6, and 2008 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Danger of scalding!

Only perform this work after engine has cooled down.

Recycling:

Catch and dispose of drained coolant in a suitable container.

Observe country-specific waste-disposal regulations.

IMPORTANT: Protect plug connections against coolant and contamination. Cover plug connections with suitable materials.

Necessary preliminary tasks:

Remove front UNDERBODY PROTECTION
Draining coolant . See 17 00 005 DRAINING AND ADDING COOLANT (N54) .

Release hose clamp (1) and detach coolant hose.

Release hose clamp (2) and detach coolant hose.

Unlock and detach coolant hose (3).

Unlock and detach coolant hose (4).

Disconnect plug connection (5).

Release screws (6).

Tightening torque 11 53 1AZ , see THERMOSTAT AND CONNECT

Remove coolant thermostat (7).

NOTE: Illustration shows coolant thermostat removed.

Fig 1: Identifying Coolant Hose, Plug Connection And Coolant Thermostat

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.