84 10 050 Removing and installing (replacing) USB hub
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
. See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary tasks:
- Remove left front seat . See SEATS - REPAIR INSTRUCTIONS or SEATS - REPAIR INSTRUCTIONS -- M3 CONVERTIBLE .
- Remove front left entrance cover strip . See 51 47 000 REMOVING AND INSTALLING/REPLACING FRONT (INSIDE) LEFT OR RIGHT ENTRANCE COVER STRIP .
- Fold back carpet for passenger compartment at front left in direction of travel
Remove USB hub protective socket (1) from footwell insert (2).
Unlock catches (3) with a suitable tool and remove USB hub protective socket cover (5).
Installation:
Make sure USB hub protective socket cover (5) engages correctly on USB hub protective socket lower section.
Seal (4) must not be damaged; if necessary, replace USB hub protective socket cover (5).
Remove USB hub (1) from USB hub protective socket lower section (2).
Installation:
Make sure rubber grommet (4) is correctly seated on USB hub protective socket lower section (2).
Disconnect plug connection (3).