66 20 565 Removing and installing/replacing front signal sensor (Park Distance Control)

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove trim panel for pedal assembly . See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .

Disconnect plug connection (1).

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip signal sensor on both sides from fixture (1).

Installation:

Signal sensor (2) must snap audibly into retaining tabs.

Fig 2: Identifying Signal Sensor On Both Sides From Fixture

Courtesy of BMW OF NORTH AMERICA, INC.