65 82 050 Removing and installing (replacing) onboard monitor

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

IMPORTANT: Proceed with care so as to avoid damaging the on-board monitor and adjoining trims.

Release screws (1).

Fold out on-board monitor (2) in direction of arrow.

Fig 1: Identifying On-Board Monitor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Installation:

Ensure correct cable routing.

Remove on-board monitor (2).

Fig 2: Identifying On-Board Monitor And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding .