65 75 071 Removing and installing (replacing) module for passenger compartment sensor

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Remove complete ceiling light (rear) . See 63 31 004 REMOVING AND INSTALLING OR REPLACING COMPLETE CEILING LIGHT (REAR, WITH MODULE FOR PASSENGER COMPARTMENT PROTECTION) .

Open retaining hooks (1) and feed module for passenger compartment sensor (2) in direction of arrow out of trim (3) and remove.

Installation:

Retaining hooks (1) must not be damaged.

Fig 1: Identifying Passenger Compartment Sensor And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding .