64 11 856 Removing and installing / replacing servodrive for central kinematics (A / C control)

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove right glovebox with housing . See 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING .

Detach right footwell heating duct (1) in area (2) in direction of arrow.

Detach right footwell heating duct (1) with adapter (3) from heater/air conditioner and remove in direction of arrow from right rear compartment heating duct (4).

Fig 1: Identifying Right Rear Compartment Heating Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release screws (2).

Detach servodrive for central kinematics (3) in direction of arrow from heater/air conditioner (4).

Installation:

Place servodrive for central kinematics (3) over guide pin (5).

Fig 2: Identifying Central Kinematics And Air Conditioner

Courtesy of BMW OF NORTH AMERICA, INC.