62 11 280 Removing and installing (replacing) instrument cluster

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) .

IMPORTANT: Risk of damage!
Carry out this operation carefully so as to avoid damaging the instrument panel.

Extend steering wheel completely and lower.

Release screws (1). Tightening torque 1.5 Nm .

Pull instrument cluster (2) forward slightly in direction of arrow.

Disconnect associated plug connection.

If necessary, feed out/unclip associated wiring harness.

Remove instrument cluster (2).

Fig 1: Pull Instrument Cluster (2) Forward Slightly In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding .

Check values for Condition Based Service (CBS) and correct if necessary.