52 26... Removing and installing/replacing ski bag with casing on rear seat (through-loading system)

WARNING: This page is about a different car, the 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove center armrest or
filler element

Press ski bag (1) on rear side out of backrest.

Fig 1: Pressing Ski Bag On Rear Side Out Of Backrest

Courtesy of BMW OF NORTH AMERICA, INC.

Lift off cover (1).

Release screws (2).

Installation:

Make sure cover is correctly installed.

Fig 2: Identifying Cover Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip single opening trim (1) towards top.

Installation:

Plastic clips must not be damaged.

If necessary, replace faulty trim.

Fig 3: Unclipping Single Opening Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Remove C-module trim (1) in direction of arrow.

Fig 4: Identifying C-Module Trim

Courtesy of BMW OF NORTH AMERICA, INC.