52 26 311 Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)

WARNING: This page is about a different car, the 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Unlock rear seat backrest and fold down.

NOTE: In event of faulty unlocking, perform emergency opening .

Unclip Bowden cable from holders (1).

Unfasten screws (2).

Tightening torque 52 26 08AZ , see 52 26 REAR SEATS (THROUGH-LOADING SYSTEM) .

Fig 1: Identifying Bowden Cable With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull lock (1) out of installation opening slightly and unclip Bowden cable (2).

Remove lock completely from installation opening.

Installation:

Catches (2) on lock must not be damaged.

Bowden cable must be correctly anchored in catches (2).

Fig 2: Pulling Lock Out Of Installation Opening Slightly And Unclip Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 3: Sliding Guide Lug Of Lock Into Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock:

Slacken screws
Firmly push engaged backrest back
Tighten down screws