52 26 303 Removing and installing/replacing actuator for left or right rear seat backrest (through-loading system)

WARNING: This page is about a different car, the 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

Unclip Bowden cable (1).

Unfasten screws (2).

Unlock catch (3) to center of vehicle and at same time unclip actuator (4) towards bottom.

If necessary, unclip actuator (4) with special tool 00 9 317 .

Fig 1: Identifying Bowden Cable, Catch And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) and (2) of actuator (3) must not be damaged.

Bowden cable (4) must be correctly engaged in actuator (3).

Fig 2: Identifying Catches And Bowden Cable With Actuator

Courtesy of BMW OF NORTH AMERICA, INC.