52 24 400 Replacing seat cover for rear seat

Special tools required: 

• 52 0 050 

See SEATS - SPECIAL TOOLS .

Necessary preliminary tasks: 

• Remove rear seat  

Unclip Isofix protective caps.

Installation: 

Make sure Isofix protective caps are correctly engaged.

Fig 1: Unclipping Isofix Protective Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out welt in area (1) with plastic wedge.

Unhook seat cover in area (2).

Fig 2: Unhooking Seat Cover In Area

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding: 

• Release all retainers in marked area.
• Remove seat cover from padding.
• Remove remaining retainers from cover and padding

Fig 3: Identifying Remaining Retainers

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert new retainer (2) with special tool 52 0 050  and bend closed.

1. Padding
2. Retainer
3. Trim thread in padding
4. Trim thread in seat cover
5. Seat cover

Fig 4: Inserting Retainer With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover: 

• Pull all trim wires out of seat cover
• If necessary, cut in take-up for trim wires of new cover
• Push trim wires into new seat cover

Fig 5: Identifying Trim Wires

Courtesy of BMW OF NORTH AMERICA, INC.