51 13 316 Removing and installing/replacing trim strip on roof gutter at left or right
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 317
See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
IMPORTANT:
Make sure that body is not damaged.
Starting at front, release trim strip (1) with special tool 00 9 317 from clips (2).
Installation:
To avoid leaks and noises, check all clips (2) for visible damage.
If necessary, replace faulty clips (2).
Align clips (2) on body and fit trim strip (1).
Installation:
Seals (1) must not be damaged.
IMPORTANT:
- Carry trim strip by its middle section only (risk of damage)
- Perform installation work with a second person helping
- Prepositioning of trim strip
- Ensure drip moulding runs parallel to side frame (risk of breakage)