51 13 286 Replacing bracket for roof luggage rack on left or right

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 322

See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove trim strip from roof frame

Remove body sealing compound (1) with special tool 00 9 322 and unfasten threaded pin (2).

Fig 1: Identifying Body Sealing Compound And Threaded Pin

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Threaded pin is designed as Torx from E87 model series.

Installation:

Threaded pin may not be wetted with screw securing adhesive on screw-in thread (1).

Before installing threaded pin, protect body against corrosion (e.g. apply zinc dust paint).

Tightening torque 51 13 1AZ , see 51 13 TRIM PARTS, COVERS, HANDLE TRIM .

Fig 2: Identifying Screw-In Thread

Courtesy of BMW OF NORTH AMERICA, INC.

Apply body sealing compound (1) (Terostat 9320, sourcing reference: BMW Parts Service) to threaded pin (2) all round.

After hardening time of body sealing compound (1), paint over body sealing compound (1) and threaded pin (2) with paint pencil of corresponding car color.

Fig 3: Identifying Body Sealing Compound And Threaded Pin

Courtesy of BMW OF NORTH AMERICA, INC.