51 61 ... Removing and installing/replacing protecting skid/mounting bracket: Notes
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions
for raising the vehicle.
Driving without the protective skid/mounting bracket is not permitted! See 00 ... ... LIFTING VEHICLE WITH A LIFTING PLATFORM .
Driving without the protective skid/mounting bracket is not permitted! See 00 ... ... LIFTING VEHICLE WITH A LIFTING PLATFORM .
Necessary preliminary tasks:
- Remove front underbody protection
Release screws (1).
Tightening torque 51 71 10AZ, see 51 71 SEALS AND LOOSE BODY PARTS ..
Release screw (3).
Tightening torque 51 71 11AZ, see 51 71 SEALS AND LOOSE BODY PARTS ..
Release screws (2) and remove protective skid (4).
Tightening torque 51 71 12AZ, see 51 71 SEALS AND LOOSE BODY PARTS ..
Installation:
Replace all screws.
Middle lug of protective skid must be situated between mounting bracket and left diagonal strut.