51 22 330 Removing and installing/replacing window cavity cover strip on inside rear door

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear door trim panel

IMPORTANT: The " Instructions on fitting window guide seals " serve as the basis for this repair instruction and must be observed without fail.

Pull window cavity cover strip at front (1) and rear (2) from rear door.

Installation:

If necessary, replace faulty retainers (3).

Moisten window cavity cover strips (1 and 2) prior to fitting with approved anti-friction agent.

Fig 1: Identifying Faulty Retainers And Window Cavity Cover Strips

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement with Security version:

Cut front window cavity cover strip to length on side of fixed door window glass to 533 mm.

Cut rear window cavity cover strip (1) to length on straight side (2) to measurement a = 153 mm.

Fig 2: Identifying Rear Window Cavity Cover Strip And Straight Side

Courtesy of BMW OF NORTH AMERICA, INC.