51 22 280 Removing and installing/replacing door retainer on rear left or right door

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Close door windows
Remove sound insulation in front area only.

NOTE: Secure rear door against falling closed.

Release screw (1).

Tightening torque 51 22 3AZ , see 51 22 REAR DOOR LOCKS .

Remove seal (2).

Installation:

Seal (2) must not be damaged.

Make sure seal (2) is correctly seated.

Fig 1: Identifying Screw And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 22 4AZ , see 51 22 REAR DOOR LOCKS .

Fig 2: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove door retainer (1) via cutout (2).

Fig 3: Identifying Door Retainer And Cutout

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of door retainer (3) must not be damaged:

Hinge
Thread

Fig 4: Identifying Parts Of Door Retainer

Courtesy of BMW OF NORTH AMERICA, INC.