51 17 400 Removing and installing/replacing bump stop with ejector for filler flap

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Release cover (1).

Press catches (2) together and pull out ejector (3).

Installation:

Install ejector (3) with fitted cover (1).

Fig 1: Identifying Catches, Ejector And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on ejector (2) must not be damaged.

Make sure cover (3) is correctly seated on ejector (2).

Fig 2: Identifying Catches, Ejector And Cover

Courtesy of BMW OF NORTH AMERICA, INC.