51 00 ... Service position of engine hood/bonnet
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 51 0 040
- 51 2 160
- 51 2 170
- 51 2 180
- 51 2 240
See BODY EQUIPMENT - SPECIAL TOOLS (CONVERTIBLE/COUPE) or BODY EQUIPMENT - SPECIAL TOOLS (SEDAN) .
NOTE:
Only the special tool pertaining to the model series can be selected.
SPECIAL TOOL REFERENCE CHART
| Model series | Special tool |
|---|---|
| E46, R50, R52, R53 | 51 2 160 |
| E53, E60, E61, E63, E64, E71, E81, E82, E88, E85, E86, E87, E90, E91, E92, E93 | 51 2 170 |
| E65, E66, E67 | 51 2 180 |
| E83 | 51 0 040 |
| E70 | 51 2 240 |
WARNING:
Risk of injury and damage!
Engine hood/bonnet must be held by a second person helping.
Engine hood/bonnet must be held by a second person helping.
NOTE:
The illustrations below serve as examples for all corresponding vehicles.
The operation is described on the left side; proceed in the same way for the right side.
The operation is described on the left side; proceed in the same way for the right side.
Special tool can only be used on housing (1) of gas spring strut (thick part).
NOTE:
Gas spring strut can also be installed the other way round (housing on hood/bonnet).
Special tool can be used in both directions.
Release gas spring strut on left/right housing side.
Slide special tool (1) over housing (2) of gas spring strut.
Clip ball socket of special tool on ball stud.
Proceed in same way on other side.