51 71 447 Removing and installing or replacing panel for cover on left or right side member

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove entrance cover strip .

Release expansion rivets (1) and screws (2).

Fig 1: Identifying Expansion Rivets And Screws

G04752872

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Screws

G04752873

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip panel (1) at front.

Unclip rear panel (1) from holder (2).

Open door and remove panel (1) in direction of arrow.

Fig 3: Identifying Rear Panel From Holder

G04752874

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on holder (2) must not be damaged.

Fig 4: Identifying Catches On Holder

G04752875

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, detach holders (1) from body and fit on panel (2).

If necessary, replace faulty holders (1).

Fig 5: Detaching Holders From Body And Panel

G04752876

Courtesy of BMW OF NORTH AMERICA, INC.