51 71 ... Removing and installing/replacing rear middle tension strut (from 03/2007)
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions
for raising the vehicle. See 00 ... ... LIFTING VEHICLE WITH A LIFTING PLATFORM
.
Driving without the tension strut is not permitted!
Driving without the tension strut is not permitted!
Release bolts (1, 2, 4) and remove tension strut (3).
Installation:
First fasten all bolts provisionally and then tighten down.
- Screw (1) M12x50
Tightening torque 51 71 22AZ, see 51 71 SEALS AND LOOSE BODY PARTS .
- Screw (4) M8x25
Tightening torque 51 71 13AZ, see 51 71 SEALS AND LOOSE BODY PARTS
IMPORTANT:
Rear tension strut must be installed below the right tension strut!