51 48 001 Removing and installing/replacing insulation lining on hood/bonnet

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Illustration created using the E87 as an example. There may be differences in detail in the case of other vehicle models.

Release threaded rivets (1) on insulation lining (2).

Remove insulation lining (2).

Installation:

If necessary, replace defective threaded blind rivets (1).

Fig 1: Identifying Threaded Rivets And Insulation Lining

Courtesy of BMW OF NORTH AMERICA, INC.