51 41 000 Removing and installing left or right front door trim panel (sedan)

Special tools required: 

• 00 9 317 

See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

Necessary preliminary tasks: 

Driver's side only: 

• Remove decorative strip from door trim panel  

  Passenger side only: 

• Remove cover on door handle  

Driver's side only: 

Release screws (1).

Tightening torque 51 41 1AZ  , see 51 41 FRONT DOOR TRIM PANEL WITH ARMRESTS .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Passenger side only: 

Release screws (1).

Tightening torque 51 41 1AZ  , see 51 41 FRONT DOOR TRIM PANEL WITH ARMRESTS .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip clips (1) for door trim panel (2) with special tool 00 9 317  .

Fig 3: Identifying Clips And Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip door trim panel (1) at top from retainers (2).

Fig 4: Identifying Door Trim Panel And Retainers

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook Bowden cable (1) from door lock (2).

Disconnect all plug connections and remove door trim panel.

Fig 5: Identifying Bowden Cable And Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace faulty clips.

Fit all clips with sealing ring.

Make sure clips are installed in correct position.

1. Grey clip
2. White clip

US/CND version: 

Crashpad (3) must be correctly fitted.

Fig 6: Identifying Crashpad

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

After assembling the door trim panel proceed as follows:

• Open door window.
• Lock with vehicle key.
• Check for ease-of-movement on retaining button linkage
  • If necessary, align linkages