41 11 734 Rear Tension Strut Mounting Complete Replacement

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Following new body parts are required:

(1) Bracket, tension strut, rear

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1).

Open weld joints in areas (2) on both sides of rear axle carrier (3).

Installation information:

To adjust new part to fit, screw down tension strut.

If vehicle is on straightening bench, adjust new part to fit with straightening attachment or universal mount.

Fig 1: Weld Joint Areas And Rear Axle Carrier

Courtesy of BMW OF NORTH AMERICA, INC.