41 11 028 Left Engine Carrier Replacement (Partial Replacement Before Front Axle)

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Place vehicle on straightening bench.

(1) Partial section, engine carrier

Fig 1: Partial Section, Engine Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut (1) in middle of 20 mm dia. bore and cut.

Preparation of new part:

Mark severance cut (1) in accordance with vehicle and cut.

Installation:

Adjust all new parts to fit with straightening attachment or universal mount.

Weld in reinforcement plate at severance cut.

Fig 2: Cut Mark

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part:

Open weld joints in areas (1).

Take off holder.

Fig 3: Weld Joint Area

Courtesy of BMW OF NORTH AMERICA, INC.