Longitudinal And Lateral Adjustment

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Open convertible top until rear module (1) is opened approx. 10 cm.

Stop opening operation in the position shown.

Fig 1: Rear Module

Courtesy of BMW OF NORTH AMERICA, INC.

Close rear end module (1) again.

Stop closing operation when the coupling fastener has locked the rear end module (1).

The correct position is reached when the rear end module (1) is flush with the side panel in area (2). If necessary, repeat procedure.

Fig 2: Rear End Module And Side Panel

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: In event of excessive height difference between convertible top compartment lid and rear lid in area shown:
Tilt convertible top compartment lid in rear area downwards.

To do so, remove spacer plates from middle and rear screw fastening points.

Fig 3: Spacer Plates

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: For purposes of clarity, picture shows and description refers to the opened convertible top compartment lid.
However, adjustment in the longitudinal direction and to the side is carried out with the convertible top compartment lid closed from the luggage compartment.

Open rear lid with ignition key.

Slacken nuts (2).

Adjust convertible top compartment lid (3) longitudinally and laterally.

Tighten down nuts (2).

Tightening torque 41 63 1AZ, see 41 63 CONVERTIBLE TOP COMPARTMENT LID .

Fig 4: Convertible Top Compartment Lid And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.