41 63 060 Convertible Top Compartment Lid Removal And Installation

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

54 0 240 , See Fig 1.

Necessary preliminary tasks:

Connect charger.
Open rear end module.

Clip special tool 54 0 240 onto hydraulic cylinder on left and right.

IMPORTANT:

The opening in the assembly support must face towards the rear of the vehicle.
Risk of damage!
Remove special tool after completing work.

Fig 1: Special Tool (54 0 240)
Courtesy of BMW OF NORTH AMERICA, INC.

Open rear lid with ignition key.

Fig 2: Opening Rear Lid With Ignition Key

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!

Tape off rear lid (1) in area shown (2) on both sides with plastic adhesive tape.

Fig 3: Tape Off Rear Lid (1) In Area Shown (2) On Both Sides With Plastic Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.

Carry over the work step shown symmetrically to the other side of the vehicle.

Pay attention to spacer plates.

Release screws (2). Tightening torque 41 63 1AZ, see 41 63 CONVERTIBLE TOP COMPARTMENT LID .

Remove convertible top compartment lid (3).

Installation:

To pre-adjust, mount the convertible top compartment lid at the screw impressions on the hinge.
Adjust convertible top compartment lid .

Fig 4: Convertible Top Compartment Lid And Screw
Courtesy of BMW OF NORTH AMERICA, INC.