41 5.... Front Side Doors Removal And Installation

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Front door:

Tightening torque 41 51 4AZ , see 51 FRONT SIDE DOORS .

Rear door:

Tightening torque 41 52 4AZ , see 52 REAR SIDE DOORS .

Fig 1: Locating Screw On Connector Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Front door:

Tightening torque 51 21 3AZ , see 51 21 FRONT DOOR LOCKS .

Rear door:

Tightening torque 51 22 3AZ , see 51 22 REAR DOOR LOCKS .

Fig 2: Door Retainer Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Secure door against falling out.

Release screws between both hinge elements at top and bottom.

Pull both screws out of hinges.

Front door:

Tightening torque 41 51 1AZ , see 51 FRONT SIDE DOORS .

Rear door:

Tightening torque 41 52 1AZ , see 52 REAR SIDE DOORS .

Fig 3: Hinge Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out door sideways and place it on a suitable surface.

Fig 4: Pulling Out Door Sideways

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Installation:

If necessary, adjust door .

Fig 5: Pulling Plug Connection From Door Pillar

Courtesy of BMW OF NORTH AMERICA, INC.