41 61 014 Engine Bonnet/Hood Adjustment

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

The specified BODY GAP DIMENSIONS serve as the basis for adjustment tasks.

Make unpainted surfaces visible by also moving the hinges.

Touch these up in the appropriate color.

NOTE: Carry over schematic representation to the relevant vehicle type.

Loosen screws (1) and (2) on left and right hinges.

Hood lid must be able to be moved.

NOTE: If the adjustment range is not sufficient, release retaining screws of engine hood hinge on body and move hinge.

Fig 1: Hinge Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Locks and retaining hook must snap correctly into place.

Adjust engine hood.

NOTE: Vertical adjustment of engine hood to side panel by means of stop pads.

Fig 2: Locating Stop Pads

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Height adjustment of bonnet to front wall:
Release screw (1) and remove cover (2).
Height adjustment by turning at closing hooks (3).

Fig 3: Screw, Hooks And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down all screw connections again.

Tightening torque 41 61 1AZ , see 61 FRONT LID .

IMPORTANT: Check function of retaining hook.