37 14 511 Replacing front ride-height sensor

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Release nut (1) and disconnect jointed rod (2).

Installation:

Tightening torque, see 37 14 3AZ in 14 ELECTRICAL COMPONENTS .

Release screws (4).

Remove ride-height sensor and disconnect plug connection (3).

Installation:

Sensor lever (5) must point from ride-height sensor to left front wheel.

Tightening torque, see 37 14 1AZ in 14 ELECTRICAL COMPONENTS ..

Fig 1: Identifying Plug Connection, Sensor Lever, Nut And Jointed Rod

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check headlight adjustment , correct if necessary. See 63 10 004 ADJUSTING HEADLIGHTS .