36 11 121 Removing and installing/replacing an RDC trigger transmitter (front)
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Partially detach front wheel arch trim . See 51 71 038 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT WHEEL ARCH COVER (FRONT SECTION) .
Press through studs (1) of expander rivets towards rear.
Remove trigger transmitter (2).
Installation:
If necessary, replace expander rivets.
After installation:
- Carry out resetting of RDC