35 31 000 Removing and installing or replacing clutch pedal

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove pedal trim . See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
If necessary, remove over-centre helper spring

Disconnect return spring (1).

Press end of pin (2) together with offset pliers and press out pin.

Detach locking clip (3) and pull clutch pedal off bearing block.

Installation:

Replace locking clip (3).

Locking clip (3) must be seated with both legs in the pin groove.

Fig 1: Identifying Return Spring, Pin And Locking Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check bearing bushings (1) and replace if necessary.

Lightly grease bearing bushings (1).

Fig 2: Identifying Bearing Bushings

Courtesy of BMW OF NORTH AMERICA, INC.