31 35 005 Removing and installing/replacing push rod (stabilizer link) for left/right stabilizer

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Note (M3 only):

Make sure stabilizer link is installed in correct position.

Connection, stabilizer link to spring strut
Connection, stabilizer link to stabilizer

Fig 1: Identifying Stabilizer Link Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove bracket for brake hose.

Release nut (3) and remove stabilizer link (2).

Installation:

Replace self-locking nuts.

Tightening torque 31 35 2AZ , see 31 35 STABILIZER BAR .

Fig 2: Identifying Stabilizer Link Nut

Courtesy of BMW OF NORTH AMERICA, INC.