17 11 046 Removing and installing / replacing module carrier

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove coolant cooler
If necessary, slacken power steering cooling coil .
If necessary, slacken A/C condenser and secure against damage and against falling down. See 64 53 550 REMOVING AND INSTALLING OR REPLACING CONDENSER FOR A/C SYSTEM .

Release damping pieces.

Fig 1: Locating Damping Pieces

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1) and remove holder (2) downwards.

Illustration shows the left holder: The same procedure applies to the opposite side.

Installation:

Rubber mounts fall out easily, ensure correct installation position.

S65 only: Engine oil cooler loose, see oil cooler .

Fig 2: Identifying Lock And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove module carrier (1) individually towards bottom.

Fig 3: Identifying Module Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing module carrier:

Convert power steering cooling loop .