12 41 041 Replacing solenoid switch

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Turn off ignition.

Remove starter motor.

Release nut (1).

Remove cable lug (2).

Fig 1: Identifying Starter Motor Nut And Cable Lug

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not turn cable lug (2) while tightening down - risk of short circuit to starter motor housing.

Tightening torque, 12 41 4AZ , see STARTER WITH MOUNTING .

Release screws (1).

Fig 2: Identifying Starter Motor Housing Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Remove solenoid switch (1) and spring (2).

Unhook pin (3).

Installation:

Check pin (3) for wear and apply grease.

Fig 3: Identifying Solenoid Switch, Spring And Pin

Courtesy of BMW OF NORTH AMERICA, INC.