Mounting engine on assembly stand (S65)

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 2 300
11 5 260

See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

See ENGINE - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove engine.
Remove rear water pipe.

Secure special tool 11 5 260 to crankcase with bolts (2).

Tighten bolts (2) evenly.

NOTE: Bolts (1) are not required on the S65.

Fig 1: Securing Special Tool (11 5 260) To Crankcase With Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Secure engine with special tool 11 5 260 to special tool 00 2 300 .

NOTE: Picture shows S85.

Fig 2: Securing Engine With Special Tool (00 2 300)

Courtesy of BMW OF NORTH AMERICA, INC.