11 00 091 Installing replacement engine (S65)

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: No running-in engine oil required.
Oil grade 10W-60

Necessary preliminary tasks:

Remove and install engine.
Flush cooling system.

Installation:

If necessary, replace following components.

Clutch
Drive belt.
All outer seals.
Replace all anti-fatigue bolts on flywheel and vibration damper.
Change coolant.
Fill engine with engine oil.