61 31 043 Removing and installing or replacing roof switch center
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 341
IMPORTANT:
Follow instructions for handling light bulbs interior lights.
See 63 99... INSTRUCTIONS FOR REPLACING LIGHT BULBS (INTERIOR LIGHTS)
.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection) .
IMPORTANT:
Reflector on ceiling light must not be damaged.
Carefully unclip trim of ceiling light (1) with special tool 00 9 341 in direction of arrow from ceiling light and remove.
IMPORTANT:
Reflector (2) and roofliner (3) must not be damaged.
Retaining clips (1) are located on centerline of both reading lights.
Carefully unlock retaining clips (1) with special tool 00 9 341.
Lever roof switch center (1) with special tool 00 9 341 in direction of arrow out of roofliner (2).
Disconnect plug connections underneath and remove roof switch center (1).
NOTE:
Disconnecting the plug connection for the hands-free microphone or emergency SOS call button results in fault memory entries in the telephone control unit (limitation in the emergency SOS call system).
After fitting, read out fault memory and if necessary delete entries.
After fitting, read out fault memory and if necessary delete entries.
Installation:
Assembling roof switch center (3) prior to installation:
- Feed in ceiling light trim (1) at line (2)
- Press ceiling light trim (1) in direction of arrow onto ceiling light
Make sure ceiling light trim (1) is correctly engaged on ceiling light.
Replacement:
- Carry out vehicle programming/coding
- Initialize slide/tilt sunroof. See 54 0... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .
- If necessary, remove bulbs.