54 37 235 Removing and installing/replacing holder for C-pillar flap

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Installation:

Microencapsulated screws (Loctite) must be replaced and may not be reused
Screw connection must be completed within 20 min. (start of curing)
Microencapsulated screws must not be retightened
Thread of nut must be cleaned beforehand in event of repeated use

Release Torx screws (1) for C-pillar flaps.

Tightening torque: 54 37 21AZ, see 54 37 POWER CONVERTIBLE TOP .

Fig 1: Identifying C-Pillar Flap Torx Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off snap ring (1).

Drive out pin and remove holder with spring.

Remove tension spring.

Fig 2: Removing Tension Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Overview of single parts .

Fig 3: Overview Of Single Parts

Courtesy of BMW OF NORTH AMERICA, INC.