54 37 025 Replacing rear roof shell seal: Notes
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 4 430
- 51 0 300
Installation:
- Screws with sealing compound must be replaced and must not be reused
- Thread of nut must be cleaned beforehand
New parts required:
- Seal
- Butylene thread dia. 4 mm
Necessary preliminary tasks:
- Remove roof lining .
- Move into assembly position
- Bring vehicle to garage/workshop temperature
Release screws (1).
Release screw (2) with special tool 00 4 430.
Tightening torque: 54 37 01AZ, see 54 37 POWER CONVERTIBLE TOP .
Pull seal off roof shell at rear.