54 37 005 Replacing front roof shell seal: Notes

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 470

Installation:

Screws with sealing compound must be replaced and must not be reused
Thread of nut must be cleaned beforehand

New parts required:

Seal
Butylene thread dia. 4 mm and dia. 7 mm
Butylene flat tape 1.5 mm x 15 mm

Measure gap dimensions in following areas with special tool 00 9 470:

between roof shell and trim strip
between front and middle trim strips

Note down gap dimensions.

Fig 1: Measuring Gap Dimensions With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Move into assembly position
Bring vehicle to garage/workshop temperature

Release left and right screws (1).

Tightening torque: 54 37 01AZ, see 54 37 POWER CONVERTIBLE TOP .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release left and right screws (1).

Tightening torque: 54 37 01AZ, see 54 37 POWER CONVERTIBLE TOP .

Remove seal from roof shell.

Fig 3: Identifying Roof Shell Left And Right Screws

Courtesy of BMW OF NORTH AMERICA, INC.