Gauge, coupling fastener

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Gauge, Coupling Fastener And Rubber Stop

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Coupling fastener must not be screwed into place for adjustment work (barrel screws move freely).

Slacken screw for rubber stop (1) and pull back.

Insert special tool 54 0 130 in coupling fastener.

Screw gauge for coupling fastener 54 0 131 on left and 54 0 132 right onto basic gauge with special tool 00 9 251 .

Tightening torque: 6 Nm

Fig 2: Locating Screw Gauge For Coupling Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Turn L-piece (2) under stop screw (3) of coupling fastener.

Adjust coupling fastener as follows:

Set stop screw (3) with adjusting screw (1) such that it comes up against stop (4).

Stop screw (3) of the coupling fastener is aligned flush at stop (4)
The L-piece (2) should ideally rest against the gauge

Bring barrel screws into contact with special tool 54 0 180 in conjunction with 00 9 450.

Tightening torque: 0.2 Nm (=20 cNm).

Fig 3: Identifying Adjusting Screw And Stop Screw With L-Piece

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe screwing sequence of coupling fastener:

Refer to INSTALLING ROOF MODULE .

Z-direction (coupling fastener to screwing plate, rollover protection system)
Y-direction (coupling faster to side panel)
X-direction (roof frame to partition wall)

Tightening torque: 54 37 22AZ, see 54 37 POWER CONVERTIBLE TOP .