11 13 020 Removing and installing/replacing lower oil sump section (N63)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove reinforcement plate . See 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE .
- Remove oil drain plug and drain engine oil.
Unlock plug connection (1) on oil level sensor and disconnect.
Release screws (2) along line.
Tightening torque 11 13 2AZ, see OIL SUMP
Remove lower oil sump section (3).
Installation:
Clean sealing surfaces.
Replace seal.
Replace bolts.
When replacing oil sump bottom section:
Convert oil level sensor.
Replace sealing ring.