11 12 006 Removing and installing/sealing right cylinder head cover (N63)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 11 4 470
See ENGINE - SPECIAL TOOLS (N54, N63) .
Necessary preliminary tasks:
- Remove acoustic cover
- Disconnect battery negative terminal . See BATTERY .
- Release battery positive terminal
- Remove right intercooler . See 17 51 001 REMOVING AND INSTALLING/REPLACING LEFT INTERCOOLER (N63) or 17 51 001 REMOVING AND INSTALLING/REPLACING RIGHT INTERCOOLER (N63) .
- Remove intake filter housing . See 13 71 030 REMOVING AND INSTALLING BOTH INTAKE FILTER HOUSINGS (N63) .
- Disconnect fuel feed line . See 13 53 332 REMOVING AND INSTALLING/REPLACING FEED LINE (N63) .
- Detach wiring harness for injectors and lay to one side.
- Remove ignition coils , cylinders 1-4. See 12 13 511 REPLACING IGNITION COILS (N63) .
- Remove injectors , cylinders 1-4. See 13 53 310 REMOVING AND INSTALLING/REPLACING AN INJECTOR (N63) .
- Remove high-pressure pump . See 13 51 065 REMOVING AND INSTALLING/REPLACING LEFT HIGH-PRESSURE FUEL PUMP (N63) or 13 51 070 REMOVING AND INSTALLING/REPLACING RIGHT HIGH-PRESSURE FUEL PUMP (N63) .
Release screws (1).
Tightening torque 11 12 9AZ, see CYLINDER HEAD WITH COVER
Remove oil filler neck (2).
Installation:
Replace sealing ring .
Release bolts in sequence (17 to 1).
Remove cylinder head cover.
Clean sealing face (1) with special tool 11 4 470.
Installation:
Replace seal (2) .
Installation:
Replace profile gasket of cylinder head cover .
Installation:
It is important to join screw (1) for exact positioning of the camshaft sensors.
Fit cylinder head cover.
Position screw (1).
Release screw (1) by 90°.
Secure cylinder head cover in sequence (1 to 17) in two work steps.
Tightening torque 11 12 3AZ, see CYLINDER HEAD WITH COVER
Assemble engine.