65 12 050 Removing and installing/replacing left or right central bass speaker (under front seat)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front seat . See SEATS - REPAIR .
If necessary, remove panel for door pillar (bottom) if equipped.

Release screws (1).

Remove central bass speaker trim (2) from floor trim (3).

Fold back floor panel (3) in direction of arrow.

Fig 1: Identifying Central Bass Speaker Trim And Back Floor Panel

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Floor panel shown removed for purposes of clarity.

Unfasten plug connection (1) and disconnect.

Unscrew nuts (2).

Feed out central bass speaker (3) in direction of arrow and remove.

Fig 2: Feeding Out Central Bass Speaker

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure seal (3) and rubber damper (4) are correctly seated on central bass speaker (1).

Insert central bass speaker (1) with guides (2) exactly in frame side member.

Fig 3: Identifying Seal And Rubber Damper With Guides

Courtesy of BMW OF NORTH AMERICA, INC.